![]() ![]() This is absolutely normal and does not in the least impair the quality. As characteristically for nature-products, colouring deviations can occur. ![]() Work blanks are eliminated, if anything could interfere the physically features of the material minimally. We only use sought out natural granite of first-class quality. If steel T-slots cross each other, it has to be defined, if there will by continuity within all T-Slots or only one T-Slot completely going through surface see picture left side, which shows an intersection. Please pay attention to the minimum distance of 100 mm up from the T-slot centre to the outer edge. Steel T-slots can be positioned optional. They are made out of non-wraping special steel and have the function of precise guidance and clamping of tailstocks. The customer is requested to define the components, which have to be connected, in the graphics. ![]() Screwed toghether an additionally glued:Ĭomponents, which could shift and/or those, which are subject to strong vibrations, will be screwed together and additionally all-over glued. 1) These bonding can also be disconnected.ģ. ![]() The components, which are screwed together, will additionally be fixed by use of adhesive. chart at the head) These bondings can be disconnected.Ģ. It is obligatory to observe the values for the distance from the border and for the engine torque. The devices are screwed together by use of gummed insert nuts. Main supporting points for custom made designsįor the custom made designs it is required that the customer states the supporting points by graphics.īonded to the control surface plate, recessed from surface approx. All other plotted points (grey ones) have the function to avoid the dander of deflection and tipping over. The red plotted points of the control surface plate define the main supporting points. The temperature gradient between ground and ceiling is mot allowed to exceed 0,2 - 0,5☌. The variation in temperature within two days is not allowed to be more than ± 0,5 ☌, to assure the standard measuring result. The planeness can be veryfied by DAkkS calibration certificate, if demanded. We will minute planeness, parallelism and squareness as stated in your engineering drawing. Tolerance category v less 100 mm, tolerance category c more than 100 mm, tolerance category f and m available against surcharge. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |